Highlights
Powerful warning module with TIR optics for maximum visibility
14 selectable flash patterns for flexible application scenarios
Silicone lens and heat-conductive base for high robustness
Technical data
Operating voltage depending on version: 10–16 V or 10–33 V
High protection class for demanding environments
Wide temperature range for year-round use
Assembly & installation
Quick installation using M3 screws or 3M adhesive tape
Hole spacing 120 mm
Hard or soft covers, bendable up to approx. 30° for curved surfaces
Certifications
ECE R10, ECE R65 HT
Explanation of HT class
The ECE-R65 HT class is equivalent to a rotating beacon (class T). When combined, the flashers must emit light at 270° in order to meet the requirements of the HT class. This means that these flashers can be used in all areas where rotating beacons would also be permitted.
Product safety information
Manufacturer information:
LED-MARTIN GmbH
Halenbacher Straße 8
Rheinland-Pfalz
Arzfeld, Deutschland, 54687
service@led-martin.de
https://www.led-martin.de/
Connection description for the TF6 HT module
Operating voltage 10â33 V DC. Use a fuse (10 A) in the positive line near the battery.
RED â + VDC
-
RED â + VDC
(+VDC voltage)
-
BLACK â − / Ground
BLUE â Light color 2
-
BLUE â Light color 2
(only in the DualColor version)
-
GREEN â Day/night input
(with + VDC night/dimming mode applied)
-
WHITE â Alternating flash
between two heads: For TWO lights with
the power supply switched off, connect the white cable only
to ONE head briefly with + VDC, insulate the other one.
The heads will then flash alternately.
-
YELLOW â Synchronization
& Pattern selection:
- Connect all YELLOW cables together to synchronize multiple heads.
To change patterns, briefly (< 1 s) connect YELLOW to + VDC and then disconnect again.
- To change patterns, briefly (< 1 s) connect YELLOW to + VDC and then disconnect again.
For a factory reset, connect YELLOW to RED (+ VDC) for longer than 5 s.
- For factory reset, connect YELLOW for longer than 5 s
to RED (+ VDC).
Notes: Insulate wires that are not used.
Only perform connection work when the power supply is switched off.
